To facilitate investigation of the effect of imperfect elastic dissipation on the propagation of Rayleigh-type channel waves and use of their quality factors in investigations of the properties of coal seams, a simple method for calculating the quality factor QR is proposed in this paper. Introduction of complex velocities into the dispersion function allows calculation of the dispersion function of Rayleigh-type channel waves in coal seams. By the control variable method, we analyzed changes in QR with changes in coal seam thickness and P-and S-wave Q-factors within the coal seam and adjacent rock layers. The numerical results show that the trend of the QR curve is consistent with the group velocity curve. The minimum QR value occurs at the Airy phase frequency;the Airy phase frequency decreases as coal seam thickness increases. The value of QR increases with increasing QS2 (quality factor for S wave in coal seam). We can compensate for the absorption of Rayleigh-type channel waves using the computed QR curve. Inversion of the QR curve can also be used to predict the thicknesses and lithologies of coal seams....
A new process of extracting vanadium from the stone coal vanadium ore in Fangshankou, Dtmhuang area of Gansu Province, China was introduced. Various leaching experiments were carried out, and the results show that the vanadium ore in Fangshankou is difficult to process due to its high consumption of acid and the high leaching rate of impurities. However, the leaching rate can be up to 80% and the content of V2O5 in the residue can be between 0.22%-0.25% in the process of ore fine grinding→oxidation roasting→mixing and ripen-ing→aqueous leaching→P2O4 solvent extraction→sulfiuie acid stripping→oxidation and precipitation→decomposition by heat. Also, the quality of flaky V2O5 produced by this process can meet the requirements of GB3283-87. The total leaching rate of vanadium is 70%. Also, three types of wastes are easy to treat. The vanadium extraction process is better in relation to the aspect of environmental protection than the sodium method....
A new technology for treating waste plastics (WP) by traditional coking process was introduced. With a thermo-balance and a 10 g atmospheric fixed bed reactor, the thermo-gravimetric behavior and product were studied during co-coking of WP with blended coal. And then, using a coke-oven with capacity of 200 kg, the characteristics of products were assessed. The results showed that there is an overlapping temperature range (200-550 ℃) of decomposition between WP and blended coal, and the pyrolysis synergism index η and synergism strength β proposed could evaluate the synergism between them. 1% of added WP results in the maximum synergism in all series experiments. The increase of added WP decreases the synergism. Tar yield in co-coking is increased with the decrease of water yield for synergism. Moreover, it was also found that the quality indexes of coke, such as M10, M40, CRI and CSR, are degraded with the increase of WP until 4%, though the quality of tar and gas is optimized for WP addition....